Lee.org

Megan got me a remote control switch set for Xmas. It works great.

It’s the Etekcity Wireless Remote Control Electrical Outlet Switch for Household Appliances (Learning Code, 5Rx-2Tx)

Instead of trying to hold onto the manual pamphlet, I put it here:

Etekcity Essentials
ZAP L-Series

Uses 1 12V / LR23A battery in the remote control
maximum load of 10 amps
transmit frequency 433.92MHz

Programming the outlets
– Note: the outlets are pre-programmed for immediate use, but the configuration can be customized to meet your needs.

To program a remote control transmitter and outlet switch receiver:
– Plug the outlet switch into a socket and turn it on.
– Press and hold the programming button on the right side of the outlet until the LED indicator begins to flash.
– Release the programming button and then press the desired On or Off button on the remote.
– The pairing is successful when the LED indicator stops flashing.

Resetting an outlet (cancel all pairings)
To cancel all pairings so that no remote control will control it:
– Remove the outlet from the power socket.
– Press and hold the programming button.
– Plug the outlet back into the power socket while continuing to hold the programming button.
– Hold the programming button for approximately 5 seconds until the LED indicator begins to flash.
– When the LED flashes rapidly several times and stops, the outlet has been reset.